From 85a5e9b7bd7fb6a6606cd70762267652d00aafef Mon Sep 17 00:00:00 2001 From: Roy Date: Fri, 30 Oct 2026 23:42:35 +0800 Subject: [PATCH] Correct the WAKE_ON_GPIO default A bootloader config without WAKE_ON_GPIO uses 0, not 1. The default Raspberry Pi 4 bootloader images set WAKE_ON_GPIO=1 in their config, which is why most boards behave as if the default were 1. Fixes raspberrypi/rpi-eeprom#915 --- .../asciidoc/computers/raspberry-pi/eeprom-bootloader.adoc | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/documentation/asciidoc/computers/raspberry-pi/eeprom-bootloader.adoc b/documentation/asciidoc/computers/raspberry-pi/eeprom-bootloader.adoc index bfca4ccb7..5fd6e7843 100644 --- a/documentation/asciidoc/computers/raspberry-pi/eeprom-bootloader.adoc +++ b/documentation/asciidoc/computers/raspberry-pi/eeprom-bootloader.adoc @@ -53,7 +53,9 @@ If `1` then `sudo halt` will run in a lower power mode until either GPIO3 or GLO This setting is not relevant for Raspberry Pi 5 and later, Raspberry Pi Compute Module 5 and later, and Raspberry Pi 500 and later, because the xref:raspberry-pi.adoc#power-button[dedicated power button] can always be used to wake from `HALT` or `STANDBY`. -Default: `1` +The default bootloader images for Raspberry Pi 4, Raspberry Pi 400 and Raspberry Pi Compute Module 4 set this value to `1` in the bootloader config. A bootloader config that does not set `WAKE_ON_GPIO` uses `0`. + +Default: `0` [[POWER_OFF_ON_HALT]] ==== `POWER_OFF_ON_HALT`